Galaxy Force Gasket/Cybertron Ransack with misassembled rear wheel hinges?

Nevermore · Post by **Nevermore** » Mon Jul 25, 2005 11:54 am

http://www.geocities.com/jeditricks/ransack/

Wildfire Herald · Post by **Wildfire Herald** » Tue Jul 26, 2005 2:41 am

Hopefully, they'll make a running change and by the time Cybertron finally reaches my area, the wheel struts will be assembled correctly. Because I'm lazy.

Nevermore · Post by **Nevermore** » Tue Jul 26, 2005 2:50 pm

Another shot at "this works"...

http://www.tfw2005.com/boards/showpost1082990-p18.html

Post by **Clay** » Sat Jul 22, 2006 2:55 am

Picked up a Ransack GTS today, which is my first copy of the mold, so I'm bumping an old topic, but...

Has anyone else managed to successfully get those pins out?

I've been fiddling with a pick off an on all day, and I'm not getting anywhere.

They should make aero-planes out the little guy... he's nigh indestructible. And it's pissing me off!

Notabot · Post by **Notabot** » Sat Jul 22, 2006 4:38 am

I tried using a vice and mousepads to hold him in place, but never got the pins to budge at all. I probably pansied out a little bit early, but using a sharp object and a hammer on a transformer... I just had to quit.

cowscows527 · Post by **cowscows527** » Sat Jul 22, 2006 4:50 am

I don't know if you've tried this, but the pins only go out one way. I can't remember which is the right side to push from. I spent hours trying to push it out before I turned him upside down. Took only a minute after.